KLINGERSIL® C-4324

Characteristic & main applications
Universal gasket material for general applications. Gasket material for liquids and steam at lower pressure and temperature, good chemical resistance against water and oil, low gas leakage.

Material
Gasket material bound with NBR, based on a combination of synthetic high-tech fibres.

Technical data

Typical values
Compressibility
ASTM F 36 J
  % 10
Recovery
ASTM F 36 J
min. % 55
Stress relaxation
DIN 52913
50 MPa, 16 h/300°C MPa 20
Stress relaxation
BS 7531
  MPa 23
Klinger hot compression 50 MPa thickness decrease 23°C % 10
thickness decrease 300°C % 25
Tightness acc. DIN 3535/6   mg/s x m <0,1
Thickness increase
ASTM F 146
oil IRM 903: 5 h/150°C % 0-5
Fuel B: 5 h/23°C % 0-10
Density   g/cm3 1,85
Meets the technical requirements of
BS 7531:2006 Grade Y

 

Technical advise
KLINGERexpert (pdf, 439KB)
The many, varied demands placed on gaskets
Gasket selection with the pT diagram
Product datasheet
Product documentation
KLINGER Hot and Cold compression test method
High temperature tightness
Surface pressures acc. DIN 28090
Gasket factors acc. DIN 28090 and EN 13555
Chemical compatibility

Technical Support
Application Overview
Important application parameters
Installation instructions
Shelf life of KLINGERSIL
Safety Information
Technical presentation
Approvals and certificates

Dimensions of the standard sheets
Sizes: 1000 x 1500 mm, 1500 x 2000 mm
Thicknesses: 0,5 mm, 1,0 mm, 1,5 mm, 2,0 mm;
other thicknesses and sizes on request.
Tolerances: thickness acc. to DIN 28091-1, lenght ± 50 mm, width ± 50mm

Function and durability
The performance and service life of KLINGER gaskets depend in large measure on proper storage and fitting, factors beyond the manufactor’s control. We can, however, vouch for the excellent quality of our products. With this in mind, please also observe our installation instructions.

Back Up

pT diagram
The Klinger pT diagram provides guidelines for determining the suitability of a particular gasket material for a specific application based on the operating temperature and pressure only. Always refer to the chemical resistance of the gasket to the fluid.