KLINGER^®Quantum

KLINGERSIL^®

   › C-4106
   › C-4243
   › C-4265
   › C-4300
   › C-4304
   › C-4324
   › C-4400
   › C-4408
   › C-4409
   › C-4430
   › C-4433
   › C-4438
   › C-4500
   › C-4509
   › C-6307
   › C-6327
   › C-8200

KLINGER^®top-sil

KLINGER^®top-graph

KLINGER^®top-chem

KLINGER^®soft-chem

KLINGER®expert
Download

Media resistance

Our company

Our Partners

News

Contact

Home

ESA Guidelines  
   Guidelines for safe 
   seal usage 

Characteristic & main applications
Excellent conformity with flange surfaces at low surface stress. For applications with low available bolt loads.

Material
Synthetic fibres and cork, bonded with NBR.

pT diagram

The Klinger pT diagram provides guidelines for determining the suitability of a particular gasket material for a specific application based on the operating temperature and pressure only. Always refer to the chemical resistance of the gasket to the fluid.

Technical Data
    

Typical values for 2 mm thickness
Compressibility ASTM F 36 J		%	30
Recovery ASTM F 36 J	min.	%	50
Stress relaxation DIN 52913	25 MPa, 16 h/100 °C	MPa	15
Klinger cold/hot compression 25 MPa	thickness decrease at 23 °C	%	16
	thickness decrease at 200 °C	%	22
Tightness according DIN 3535/6		ml/min	0,1
Thickness increase after fluid immersion ASTM F 146	oil IRM 903: 5 h/150 °C	%	5
	fuel B: 5 h/23 °C	%	7
Density		g/cm3	1,0

Technical advice
KLINGERexpert (pdf, 410KB)
The many, varied demands placed on gaskets
Gasket selection with the pT diagram
Product documentation (pdf, 877KB)
KLINGER Hot and Cold compression test method
High temperature tightness
Surface pressures acc. DIN 28090
Gasket factors
Chemical compatibility

Technical support
Application overview (pdf, 525KB)
Important application parameters (pdf, 410KB)
Installation instructions (pdf, 421KB)
Shelf life of KLINGERSIL (pdf, 408KB)
Material safety data sheet (pdf, 77KB)
Technical presentations
Approvals and certificates

Dimensions of the standard sheets
Sizes: 1000 x 1500 mm, 1500 x 2000mm
Thicknesses: 0,5 mm, 1,0 mm, 1,5 mm, 2,0 mm, 3,0 mm;
other thicknesses and sizes on request.
Tolerances: thickness ± 10%, lenght ± 50 mm, width ± 50mm

Function and durability
The performance and service life of KLINGER gaskets depend in large measure on proper storage and fitting, factors beyond the manufactor’s control. We can, however, vouch for the excellent quality of our products. With this in mind, please also observe our installation instructions.